FARGO electronic C16 Using the Print Length option, Rear of Printer, Front of Printer

RESTRICTED USE ONLY Fargo Electronics, Inc.

Using the Print Length option

Use this option to reduce or increase the overall printable area in order to optimize edge-to- edge printing toward the trailing edge of a card. (Note: When adjusting this value, keep in mind that cards always remain in the same position while moving through the Printer.)

The diagram (below) represents how the end of form will move in relation to the fixed card position as a positive or negative Print Length value is entered.

Step Procedure

1Click on the left arrow to enter a positive value to reduce the print length and move the end of the printable area more toward the leading edge of the card.

OR

Click on the right arrow to enter a negative value to increase the print length and move the end of the printable area more toward the trailing edge of the card.

•Printed Image Direction: Notice the arrows on these buttons indicate the direction the length of the printable area will move on the card.

•Maximum Adjustment Range: The maximum adjustment range is ±100. As a rule, 10 equals about .030"/. 8mm, which is about the same as the thickness of a standard CR-80 size card.)

Rear of Printer

	-
Card Output	Card Input
Side of Printer	Side of Printer
(Leading Edge	(Trailing Edge
of Card)	of Card)
	Direction card travels through printer
	Front of Printer

Persona￿ C16 Card Printer Service Manual (Rev. 5.0) 81