RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Board, Interface and Printhead Replacements
Replacing the Print Circuit Board (D810059)
Refer to Drawings 830117, 830118 and 830119.
Estimated Repair Time: 30 minutes.
Steps | Procedure |
|
|
1 |
|
| Caution: Turn off the Printer and unplug the power cord from the |
| Printer. |
|
|
2 | Open the Upper Imaging Assembly. |
|
|
3 | Loosen the top two corner screws (130987) found just behind the top edge of |
| the Rear Cover. |
|
|
4 | Close the Upper Imaging Assembly. |
|
|
5 | Remove the screw (130987) by the Card Exit Ramp. |
|
|
6 | Remove the Rear Cover. |
|
|
7 | Remove the two screws (130971) that secure the Print Circuit Board to the two |
| Standoff screws (140047). |
|
|
8 | Remove the screws that hold the Main Board Brackets in place. |
|
|
8 | Use the thumb and index fingers of both hands to carefully pry the Print Circuit |
| Board from the Power Circuit Board. |
|
|
9 | Remove all of the cables from the Circuit Boards. |
|
|
Persona C16 Card Printer Service Manual (Rev. 5.0) | 164 |