Wayne-Dalton 8300/8500 Optional Installation, Trolley Arm Hookup, Side Lock, Pull Rope

Optional Installation

Trolley Arm Hookup

Tools:

NOTE: If Wayne-Dalton operator/ trolley bracket was installed, follow these directions.

Align hole in the door arm with holes in operator bracket tabs, as shown. Attach with 5/16” x 1-3/4” cotter pin and cotter ring.

Drawbar operator	5/16” x 1-3/4”
	Clevis pin
bracket tabs
Cotter
ring	Cotter ring
5/16” x 1-3/4”	Typical trolley arm
Clevis pin

Side Lock

Tools: Power drill, 7/16” Socket driver, Tape measure

Install the side lock on the second section of the door. Square the lock assembly with the door section, and align with the square hole in the vertical track. The side lock should be spaced ap- proximately 1/8” from the section edge. Secure the lock to the section with (4) 1/4”-20 x 11/16” self drilling screws.

Important: Side locks must be removed or made inoperative in the unlocked position if an operator is installed on the door.

	Square hole in
	vertical track
Second section
	(4) 1/4”-20 x 11/16”
	Self drilling screws
Side lock	1/8”
End stile

Pull Rope

Tools: Power drill, 1/8” Drill bit, Tape measure

WARNING

Do not install pull ropes on doors with electric operators. Chil- dren may become entangled in the rope causing severe or fatal injury.

Measure and mark the jamb approximately 48” to 50” (1220 to 1270 mm) from floor on the right or left side of jamb. Drill 1/8” pilot hole for no. 6 screw eye. Tie the pull rope to the no. 6 screw eye and to the bottom bracket as shown.

No. 6 Screw eye

Bottom bracket

48” to 50”

From floor

Pull rope

Pull rope

15

Please Do Not Return This Product To The Store. Contact your local Wayne-Dalton dealer. To find your local Wayne-Dalton dealer,

refer to your local yellow pages business listings or go to the Find a Dealer section online at www.Wayne-Dalton.com