RESTRICTED USE ONLY

Fargo Electronics, Inc.

Running the Self Test

Perform a self-test after (a) an initial setup of the Printer, (b) a calibration procedure has been conducted or (c) a part has been replaced to check for proper Printer operation.

Step Procedure

1Verify that a full-color ribbon is installed and that cards are properly loaded.

Caution: If the power is ON, disconnect the Power Cable from the Printer’s rear panel.

2Press and hold the Pause/Resume button.

3While holding down the Pause/Resume button, plug the power cable back into the Printer.

4The Printer will print a 3-color process gray scale on the front, flip the card and print the monochrome black panel on the back. The overlay pass is not printed during the Self-test.

Running the Standard Self Test Print

This card will be printed.

PRO-LX

Persona￿ C16 Card Printer Service Manual (Rev. 5.0)

63

Page 72
Image 72
FARGO electronic C16 service manual Running the Self Test, Running the Standard Self Test Print