FARGO electronic C16 Replacing the Printhead Harness Assembly 830162-00 continued, Steps

RESTRICTED USE ONLYFargo Electronics, Inc.

Replacing the Printhead Harness Assembly (830162-00) (continued)

Steps	Procedure
15	Use the thumb and index fingers of both hands to carefully pry the Print Circuit
	Board from the Power Circuit Board.
16	Open the Upper Imaging Assembly.
17	Remove the screws from the four corners of the top cover.
18	Close the Upper Imaging Assembly.
19	Lift the top cover from the Printer
20	Take the two screws (130990) from the Fan Guard (150312); lift the fan out of
	the Printer.
21	Remove the two screws (130971) that secure the Shield Sensor (810303) to the
	Sensor Mount Bracket (810221).
22	Take the Ribbon Sensor Assembly from the Printer.
23	Remove the screw (130972) that secures the Headlift Sensor Switch to the
	Front Plate/Print Assembly Sideplate (830302).
24	Lift the Headlift Sensor Switch out of the Printer.
25	Cut the Tie Wrap (140013) that attaches the Head Harness Assembly to the
	Back Plate/Print Assembly Sideplate (830303).
26	Disconnect the cable connectors
27	Take the Printhead Harness Assembly from the Printer.

Persona￿ C16 Card Printer Service Manual (Rev. 5.0) 168