RESTRICTED USE ONLY | Fargo Electronics, Inc. |
Board Errors
Resolving the EE Memory Error
Symptom: An error has occurred in the permanent circuit memory.
Step Procedure
1Reboot the Printer.
2If the problem persists, the Main Print Board will need to be replaced. See Replacing the Main Board procedure in Section 5, page 164.
3As an alternative to replacing the Main Print Board, the chip U1 (080196) may be replaced. (Note: Fargo recommends that only a qualified electronics technician perform this procedure.)
Resolving the DRAM Memory Error
Symptom: An error has occurred in the removable memory module (SIMM).
Step Procedure
1Reboot the Printer.
2If the problem persists, the Main Print Board will need to be replaced. See Replacing the Main Board procedure in Section 5, page 164.
3As an alternative to replacing the Main Print Board, the chip U23 (080194) may be replaced. (Note: Fargo recommends that only a qualified electronics technician perform this procedure.)
Sensor Testing
Step Procedure
1Check the voltage to determine if a Sensor is working.
2a. Test the voltage of each Sensor using ground (GRD = Chassis) unless noted to the correct pin on each connector. See Sensor Location and Voltages table on the next page.
b.Block a Slot Sensor with a card.
c.Depress a switch style Sensor.
Persona C16 Card Printer Service Manual (Rev. 5.0) | 206 |
