FARGO electronic C16 service manual Cleaning the Card Feed and Cleaning Rollers

RESTRICTED USE ONLY Fargo Electronics, Inc.

Cleaning the Card Feed and Cleaning Rollers

The Card Feed Rollers move the card throughout the print process. (Note: The Cleaning Roller removes dust particles from a blank card as it feeds into the Printer. Clean these rollers to prevent card jams and card contamination and ensure better print quality and extended Printhead life.)

Step	Procedure
1	a. Ensure a consistent Printer operation by cleaning these rollers approximately
	every 250 prints or during every ribbon change, depending on the
	cleanliness of the card stock and the environment (in which the Printer is
	located).
	b. Clean the rollers if the rollers appear dirty or if the cards start showing
	speckles or debris on the printed surface by following Steps 2 to 7 (below).
2	Leave the Printer power ON and open the Printer's Top Cover.
3	Remove all cards from the Printer's Card Input Hopper.
4	Get a Cleaning Card from the Printer Cleaning Kit and remove its adhesive
	backing paper.
5	Insert the Cleaning Card into the card output end of the Printer until the card
	stops.
	Caution: Be sure to insert the card so that the longest end of the card
	is inserted first with the sticky side facing up.
	Continued on the next page

Persona￿ C16 Card Printer Service Manual (Rev. 5.0) 151