Using Your Air Purifier, Introduction | Hunter Fan 30180 specification

SAFETY INSTRUCTIONS

Save These Important Instructions

1.This Air Purifier is designed for use on a flat, level surface and may not work properly on an uneven surface. ALWAYS place this Air Purifier on a firm, level surface. ALWAYS place the Air Purifier at least six (6) inches away from walls and three (3) feet from heat sources such as stoves, radiators, or heaters.

2.Place the Air Purifier in an area that is out of the reach of children.

3.Before using the Air Purifier, extend the cord and inspect for any signs of damage. DO NOT use the product if the cord has been damaged.

4.To reduce the risk of electric shock, this product has a polarized plug (one blade is wider than the other) as a safety feature. This plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat or override this safety feature.

5.ALWAYS UNPLUG the Air Purifier when it

is not in operation, while the filter is being changed, and while it is being cleaned.

6.DO NOT tilt or move the Air Purifier while it is in operation. Shut off and unplug before moving.

7.DO NOT immerse the Air Purifier in water as permanent damage will occur. Refer to and follow the CLEANING AND FILTER REPLACEMENT instructions.

8.DO NOT run the ionizer if tobacco smoke, air fresheners, dripless wax candles, or grease from cooking is present.

quickly and effectively removing dust, smoke, and pollen particles as small as .3 microns in size. Room air is pulled in through the front grill where larger particles and odors are caught on the pre-filter. Smaller particles passing through the pre-filter are caught on the main filter. The ionizer helps remove the remaining particles before being pushed back into the room through the top vent.

Using Your Air Purifier

1.Take the air purifier out of the box and remove the clear plastic protective bag. Place the unit on a firm level floor.

2.Before turning on the air purifier, you need

to confirm that the filters are firmly in place and have not become loose during shipping. To check the filters, open the front grill by placing your fingers under the handle and pulling the front grill towards you. The front grill will rest at about 45º. You may then remove the front grill by placing your fingers under the handle and pulling the front grill up.

3.The carbon pre-filter is mounted inside the front grill with hook tape. Confirm that it properly covers the grill vents. You may notice a few black particles coming off the pre-filter. Those particles are part of the odor-removing activated carbon and will be collected on the filter during use. The HEPAtech filter should rest loosely inside the unit with the arrow on the side of the filter showing air flow and the direction the filter should be installed.

Introduction

4.Place the front grill back onto the unit. First, line up the tabs on the bottom of the grill

Thank you for purchasing the HEPAtech™ Air		with the openings on the purifier base and
Purification System from Hunter Fan Company.		then push the top of the grill forward until it
You have purchased our latest development in		is closed. NOTE: This unit will not operate
portable Air Purification Systems. This system		unless the grill is in the correct position.
has been developed to improve the quality of
the air you breathe.		5. Plug the unit into a 120V electrical outlet.
Our HEPAtech™ Air Purification System out
performs other air purification systems by

©2010 Hunter Fan Company	2	43063-01 20100615