Operating Your Air Purifier

OFF	Unit off
	Low speed - Recommended for use when soft
	background noise is unwanted.
	Medium speed - Typical usage setting. Soft
	background noise is not an issue.
	High speed - Use when quick, efficient results
	to a room’s air quality are desired.

The fan speed can be adjusted at any time by rotating the dial so the indicator light aligns with the desired speed.

Press the UVC Light Button to turn on and off the UVC function of your Air Purifier.

NOTE: The ON/OFF Indicator and the UVC Indicator will stay lit while the fan and/or UVC is running.

Air Purifier Maintenance

It is necessary to periodically check your Air Purifier for performance. If the Pre-Filter and/or HEPA Filters are covered in dust and other captured particles, it will be necessary to clean or replace one and or both. The Pre-Filter and Filters should be checked at least every 6 months. The UVC Light should be replaced every year.

NOTE: Some environments may require more frequent cleaning of each filter. In these situations, adjust the time you check your filters to ensure the filters stay clog free to optimize performance.

Check or Clean Your Pre-Filter

1.Turn the Air Purifier off and disconnect from the wall.

2.Remove the rear grill on the back of the unit by pressing the tab at the top of the unit, under the handle and pull the rear grill outward. Figure 7.

3.Turn the Rear grill over and gently remove the Pre- Filter from the grill.

4.Check the Pre-Filter side facing the grill for particle coverage.

UVC ON/OFF

UVC

Indicator

Speed control

ON/OFF

Indicator

Figure 6.

Press

Down

Figure 7.

44030-01 20100119