Check or Replace Your Filters

5.If the Pre-Filter needs to be cleaned, It may be submerged in warm soapy water to clean. Gently lift and submerge the filter several times to clean.

6.When complete, rinse the filter with warm water and allow to dry completely.

Note: Wet parts placed into the unit can cause damage to the filters and or the motor of the Air Purifier.

1.Turn the Air Purifier off and disconnect from the wall.

2.Remove the rear grill on the back of the unit by pressing the tab at the top of the unit, under the handle and pull the rear grill outward. Figure 7.

3.Remove the HEPA Filters from the unit.

4.Check the Filters for particle build-up.

5.The HEPA filter should be removed every 12 months of use and matched to the color indicator on the inside of the filter compartment. When the filter matches the dark, charcoal gray indicator, it should be replaced.

Replace The UVC Bulb

The UVC light should be replaced once yearly. Follow these instructions to remove and replace the UVC bulb.

1.Unplug the unit from the wall outlet and remove the back grill by pressing down on the top tab.

2.Remove the 2 screws holding the Photcatalytic Screen in place and remove the screen. Figure 9.

3.Remove the 3 screws holding the UVC Guard in place and remove it from the unit. Figure 10. & 11.

4.Grasp the bulb with your thumbs and forefingers at the plastic top and bottom and gently roll the bulb to the left. Figure 12.

5.When the bulb releases, slide the top of the bulb out of the bracket and remove.

6.Partially remove the new UVC Bulb from it’s packaging being careful not to let the bulb come in contact with your skin.

Screws

Figure 9.

Screws

Figure 10.

Figure 11.

44030-01 20100119