Manual Operation
Your SOLO2 Air Cleaner has the ability to work separately from your computer. Turn the SOLO2 off, unplug your USB cable from SOLO2, and unplug the Power Adapter from the wall. You may now move the SOLO2 to anywhere in your home or office.
NOTE: When using the touch panel on the front of the SOLO2, you must use your fingertips to operate the controls. Finger nails, pens, pencils, etc will not work to activate or control the unit.
On / Off Air Flow Control
To turn your SOLO2 unit on, press the up and down touch pads on the unit simultaneously. Figure 5. Once on, press the up or down arrow pads to adjust the fan speed. To turn your SOLO2 unit back off, press the up and down touch pads simultaneously again.
Touch
Sensitive
Areas
Figure 5.
Air Cleaner Maintenance
Cleaning
Proper maintenance of your Hunter Air Cleaner will help ensure years of trouble free service. Follow these steps to properly maintain your air purifier:
1.Approximately every 90 days, the outside of the unit should be cleaned with a soft, damp cloth.
2.Follow the instructions for Changing the Filter on this page to determine when and how to replace the filter.
NOTES:
•The air cleaner must be unplugged from your computer and the power outlet during the cleaning process.
•Be sure the unit is completely dry before plugging it in and using.
•Never immerse the SOLO2 in water or use harsh chemicals to clean.
Changing the Filter
1.To change the filter in your SOLO2, turn the unit off, unplug the power cord, and USB cable.
2.Turn the SOLO2 on it’s side and remove the wire base from the bottom of the unit by compressing the hinges on either side of the wire base (a) and gently pulling each out of the bottom of the SOLO2 unit (b). Figure 6.
b.Pull to remove
a. Pinch 
Figure 6.
©2008 Hunter Fan Co. | 6 | |
|