MAINTENANCE
DAILY MAINTENANCE SCHEDULE
The following services should be performed daily or every 8 hours of service, following the detailed maintenance instructions in the operators manual.
______ Pump Drive Shaft: | If required with drive shaft / coupler check for | |
|
| end play and lubricate at zerks. |
______ | Crankshaft adapter: If equipped with rubber grommets check | |
|
| condition, replace if missing or damaged. |
______ | ||
| (Check Maintenance Section) | |
______ | Hydraulic fittings: Check for leaks with paper or cardboard. Tighten | |
|
| fittings or replace hoses immediately. |
______ | Knives: Inspect for missing or damaged knives, change (only | |
| complete sets) as needed. | |
______ | Belts: Check / Tighten / Replace belts as needed. | |
______ | Main Frame / Deck: Unless otherwise specified retorque bolts | |
|
| according to torque specifications in this |
|
| section. |
______ | Hydraulic Fluid Level: Add, if required, per fluid recommendations. | |
______ | Rear Flail Drive, Bearing | |
| Flange and Shaft Couplers: Grease as instructed in the detailed | |
| (if applicable) | maintenance section. |
______ | Cutter Shaft and Ground Roller: Grease as instructed in the detailed | |
|
| maintenance section |
Service performed by:_______ Date:____/____/____ Hour
Meter:__________
Maintenance Section
** This page may be copied and used as part of the daily maintenance routine.
JD 7X30 COUGAR ROT Maintenance Section
