3.6Cleaning and maintenance Burners
■Remove the burner caps, burner head and burner ring by pulling them upwards and away from the top plate.
■Soak them in hot water and a little detergent.
■After cleaning and washing them, wipe and dry them carefully. Make sure that the flame holes are clean and completely dry.
■Wipe the fixed parts of the burner base with a damp cloth and dry afterwards.
■Gently wipe the thermocouple and spark plug with a well
■Make sure that the injector is not blocked before placing the burners back on the top plate.
Assemble the auxiliary,
12
14
15
16
11
12
13
14
15
16
Replace the burner head (12) by ensuring that the locating tabs fit into the notches in the burner base (14).
Place the burner head (12) on the burner ring (13) so that the thermocouple (15) and the spark plug (16) extend through their respective holes in the burner head.
Replace the burner cap (11) by ensuring that the locating tabs fit into the notches in the burner base (14).
Replace parts in the correct order after cleaning ■ Do not mix up the top and bottom.
■The locating lugs must fit exactly into the notches.
■Set the pan supports down vertically without sliding them over the spillage well.
GB 20
