Whirlpool 4371006 If range does not Operate, For cleaning Maintenance, If you need Assistance

n

Broil burner:

Turn the orifice hoods down snug onto pins (approximately

2 to 2- l/2 turns).

DO NOT OVERTIGHTEN.

D n Oven burner: Turn the orifice hood

down snug onto pin (approximately 2 to 2- 1/2 turns). DO NOT OVERTIGHTEN. The burner flame cannot be properly adjusted if this conversion is not made.

Adjusting for proper flame:

lock screw

air shutter

orke hood

Product Damage

Electric ignitors are used to light the oven and broil burners. Do Not insert any object into the openings of the shield surrounding the ignltor coil.

Do Not clean this area.

Failure to follow these instructions could result in product damage.

A fl After all burners have been converted, turn the range gas supply valve back on.

B w Cooktop burners: No burner adjustment can be made.

Part No. 3160029@4/4371006 Rev. B 01993

C n Broil burner:

1.Loosen the lock screw on the air shutter located at the rear of the broil burner.

2.Adjust the air shutter as needed. The

flame should have a 1’ long inner cone of bluish-green with an outer mantle of dark blue. The flame also should be clean and soft in character with no blowing or lifting of flame. Tighten the lock screw.

D n Oven burner: Locate the air shutter near the center rear of the oven burner. Loosen screw and adjust the air shutter as needed. The flame should have a 1’ long, inner cone of bluish-green, with an outer mantle of dark blue. The flame also should be clean and soft in character with no blowing or lifting of flame. Tighten screw.

E n Replace the oven bottom, oven racks, baffle and storage drawer. Reinstall cooktop and burner grates.

After installation is complete, make sure all controls are left in the “OFF”position.

Reset all controls to the “OFF”position after

using a programmable timing operation.

Make sure the air flow from the oven vent and the air flow to the bottom front of range is unobstructed.

If range does not

operate...

l Check that the circuit breaker is not tripped or the house fuse blown.

l Check that the power supply cord is plugged into wall receptacle.

l Check that the gas supply is turned on.

NOTE: Refer to Use and Care Guide for operating instructions and cleaning

instructions.I

Benton Harbor, Michigan 49022

For cleaning and

maintenance...

If removing the range Is necessary for

cleaning or maintenance, shut off gas supply to the range. Disconnect the gas and electric supply.

If the range or electrical supply is inaccessible, Ilft the range slightly at the front and pull the range out away from the wall. Pull the range out only as far as necessary to disconnect the gas and electric supply lines.

Remove the range to complete cleaning or maintenance.

Move range back into operating position. Insert cable into anti-tip bracket. Level the range. Connect gas line to range and check for leaks. Make sure that cable is secure in anti-tip bracket. Plug electric power supply cord into outlet.

Personal Injury Hazard

Do Not step, lean or sit on the range or the door or drawer of the range.

Failure to follow this instructlon could result in personal injury and/or product

damage.

If you need

assistance...

Check your Use and Care Guide for a toll- free number to call or call the dealer from

whom you purchased this appliance. The dealer is listed in the Yellow Pages of your phone directory under ‘Appliances - Major.”

When you call, you will need the range model number and serial number. Both numbers can be found on the serial/rating plate located under the cooktop.

Printed in U.S.A.