MAINTENANCE

GREASING CUTTER SHAFT – FLAIL MOWERS

Locate grease zerks on each end of cutter shaft(s), these are located on the bearing cover. Normal conditions require one or two pump in each bearing, using Lithium-Complex Extreme Pressure grease conforming to NLGI2-ISO 320 specifications. This is to be done with a standard grease gun daily or at 8 hour intervals.

CAUTION: Over greasing may cause premature seal failure.

GREASING GROUND ROLLER SHAFT – FLAIL

Locate grease zerks on each end of roller tube at lower rear of head. Normal conditions require one or two pump in each bearing, using Lithium-Complex Extreme Pressure grease conforming to NLGI2-ISO 320 specifications. This is to be done with a standard grease gun daily or at 8 hour intervals.

CAUTION: Over greasing may cause premature seal failure.

JD 7X30 COUGAR Maintenance Section 4-12

Page 89
Image 89
Tiger Products Co., Ltd 7X30 manual Maintenance Greasing Cutter Shaft Flail Mowers, Greasing Ground Roller Shaft Flail