Tiger Products Co., Ltd 7X30 manual Work on the Implement. Place the Mower Head on the ground or

(SBM-12a)

(SBM-11)

(SBM-9)

	SAFETY
	Relieve hydraulic pressure prior to doing any maintenance or repair
	work on the Implement. Place the Mower Head on the ground or
	securely supported on blocks or stands, disengage the PTO, and turn
	off the engine. Push and pull the control Levers or Joystick several
	times to relieve pressure prior to starting any maintenance or repair
	work. (SBM-6)
DANGER!	Always keep a careful lookout and use extreme care when working
	around overhead obstructions. Never allow the Mower head or boom
	within 10 feet of any power line. When working close to overhead power
	lines consult your electric company for a safe code of operation.
	(SBM-7)
DANGER!	When transporting Boom Mower on a truck or trailer, the height or width
	may exceed legal limits when the boom is in the transport position.
	Contact with side or overhead structures or power lines can cause
	property damage or serious injury or death. If necessary lower boom to
	reduce height and/or remove mowing head to reduce width to the legal
	limits. (SBM-8)

DANGER!

DANGER!

Never operate the Tractor and Mower Unit without an OPS (Operators Protective Structure) or Cab to prevent injury from objects thrown from ground or from overhead trimming. Stop mowing if workers or passersby are with in 100 yards.

Each Rear Wheel must have a minimum of 1500 pound contact with the surface to prevent lateral instability and possible tip-over which could result in serious bodily injury or even death. Widen the wheel tread and add weights if needed. Refer to the mounting instructions or call Customer Service if you need assistance with Couterweight Procedure.

DANGER! Always disconnect the wire leads from the mower pump solenoid before performing service on the Tractor or Mower. Use caution when working on the Tractor or Mower. Tractor engine must be stopped before working on Mower or Tractor. The Mower Blades could inadvertently be turned on without warning and cause immediate dismemberment, injury or death.

DANGER! The flail cutter shaft is designed for standard rotation (same

rotation as the tractor wheels during forward travel). Never operate the cutter shaft in the reverse rotation. Operating this mower in reverse rotation may cause objects to be thrown out the front of the mower head.

JD 7X30 COUGAR Safety Section 1-10