Hunter Fan 33283 manual Humidifier Parts, Humidifier Features, Using Your Humidifier

Humidifier Parts

	Humidistat
Power/Speed	Controls	PermaWick™
		Filter Frame
Control			Easy Tote
	PermaWick™		Handle
		Filter
		Water
		Tank

Main

Housing

Tank

Cap

Base

Figure 1

Humidifier Features

Adjustable Humidistat: Enables you to set a desired maximum humidity level. Once this level is reached, the unit will shut off until the humidity level drops.

NOTE: The humidifier may not be running because the humidistat setting may need to be adjusted.

Power/Speed Control: Turns the humidifier ‘ON’ and ‘OFF’. The power should always be off before unplugging the humidifier, moving the humidifier, or refilling the water tank. Power Light: The light will be illuminated when the power is on.There are 2 fan speeds, high and low.

NiteGlo™ Night Light Control: Turns the night light ‘ON’ and ‘OFF’. The night light can be turned on even if the humidifier fan is turned off.

NiteGlo™	Power/Speed
Night
	Control
Light
Control
	Power
	Light

Using Your Humidifier

1.Remove The Care Free® Evaporative Humidifier from its packaging. Read and Save the Instructions.

2.Place the humidifier on a hard, flat, water resistant surface. Always place the humidifier at least six (6) inches away from walls and sources of heat.

3.Lift the main housing to confirm that the PermaWick™ filters are placed upright in the slots. Replace the main housing. (See Figure 1.)

4.Remove the water tank and take it to the sink or tub to fill.

5.Turn the tank upside down and unscrew the tank cap by turning it counterclockwise. Fill the water tank with cool water and replace the tank cap (Never use hot water). Be sure not to fill the tank to overflowing as water damage may occur to furniture or flooring due to spillage.

HUNTER WILL NOT ACCEPT RESPONSIBILITY FOR DAMAGE TO PROPERTY CAUSED BY WATER SPILLAGE.

6.Carry the tank back to the humidifier. Turn the tank upright and place the full tank on the unit and allow the water to fill the bottom tray. Be sure that the tank is seated properly in the base. If the tank is properly located on the base, you will see air bubbles flowing up into the tank.

7.With the power control knob in the ‘OFF’ position, plug the humidifier into the wall.

CAUTION: Never plug in the Humidifier while your hands are wet as Electric Shock could occur.

8.Once the water is at the proper level, the tank will stop bubbling. Run the unit on “HI” speed for 11⁄2 minutes for optimum pump operation. Set the unit to the desired speed.

9.You can choose the desired humidity output by adjusting the Adjustable Humidistat knob. In a very dry room, the “HI” setting should be used to quickly achieve a comfortable level of humidity. Once the room is comfortable, you can turn the Adjustable Humidistat down. Selection of your desired humidity level is a personal choice and you may have to adjust the dial to find the level where you feel most comfortable. To begin with, we suggest you try a middle location between the lowest and the maximum setting. Then, adjust the level to suit your needs.

10.When the humidity reaches the level you have set, the Humidifier will shut off. The humidifier will not output humidity while the humidity in the room is at the selected humidity level. When the humidity in the room drops below the selected level, the humidifier will cycle on again.

Adjustable

Humidistat

Control

Figure 2

©2008 HUNTER FAN CO.

11.Follow REFILLING THE WATER TANK directions.

12.Use the control button to turn the night light off and on. The night light can be operated even if the humidifier fan is turned ‘OFF’.

3 43050-01 06/04/08