Hunter Fan 23838 warranty Wiring the Fan, For Dual Switch Wiring see Fig

Wiring the Fan

! CAUTION !

BE CERTAIN THAT THE ELECTRICITY IS TURNED OFF AT THE

MAIN PANEL BEFORE STARTING THIS SECTION.

NOTE: All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70-1999. If you are unfamiliar with wiring, use a qualified electrician.

Wall switches are not included. Select an
acceptable general-use switch in accordance with	Wire Connector
national and local electrical codes.

1.Before attempting installation, make sure the power is still offf.

2.To connect the wires, use the wire connectors

	provided in the hardware bag. Hold the
	bare metal leads together and place a wire		Ground
	connector over them, then twist clockwise
	until tight.		Wire
3.	Connect the bare or green ground wire
	(grounding) from the ceiling to the side of the
	hanger bracket assembly.
4.	Connect the white wire (grounded) from the
	ceiling to the white wire (grounded) from the
	fan.
		Fig. 8
5.	Connect the remaining wires as follows for
	either Dual or Single Switch Wiring:

For Dual Switch Wiring (see Fig. 8):

•The black wire (ungrounded) from the ceiling to the black wire (ungrounded) from the fan.

•The blue wire (ungrounded) from the fan to the wire (ungrounded) from the wall switch.

For Single Switch Wiring (see Fig. 9):
• The black wire (ungrounded) from the ceiling
to the black (ungrounded) and the blue wire	Ground
(ungrounded) from the fan.	Wire

! CAUTION !

NO BARE WIRES OR WIRE STRANDS SHOULD

BE VISIBLE AFTER MAKING CONNECTIONS.

6.	Turn the splices upward and push them carefully
	into the outlet box.
		Fig. 9
7.	Spread the wires apart, with the grounded

wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box.

Hunter Fan Company

9

41532-01 • 11/05/14