6
All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, you should use a qualified electrician.
|
| (Note: Wall | |
Wall Switch Wire for Separate | switch must be | ||
Control of Light Fixture | acceptable as a | ||
Power |
| ||
Black | switch.) | ||
Wires | |||
|
| ||
in | White |
| |
Ceiling | Bare or Green |
| |
|
| ||
2 x 4 Brace |
| Outlet Box | |
|
|
3.Raise the canopy, be sure the holes in the canopy and the ceil- ing plate are aligned, and loosely assemble the canopy screws one at a time. When all three screws are assembled, securely tighten all three canopy screws. Refer to Figure 15.
Tab Hole
and Tab
Canopy
Screw
Figure 15 - Installing the canopy
Approved
Connectors
Green Ground Wire from Hanger Pipe (not present with flush mounting option)
White | Black |
1
2
Blk/Wht
3Wires from Fan
Ceiling Plate
Connections:
1.Connect Blk/Wht wire from the fan to the wall switch for separate control of the light fixture, or
2.Connect Blk/Wht wire from the fan to the ceiling black wire if there is no separate wall switch wire for the light fixture.
installing the canopy trim ring
1.To easily install the canopy trim ring, locate the two tabs on the canopy trim ring. See Figure 16.
| Canopy |
Press Here when | Press Here when |
Removing | Removing |
Figure 13 - Wiring the fan
installing the canopy
1.Rotate the fan 180º clockwise from the initial position when hanging the fan. The arrows on the hanger ball and on the ceiling plate should be pointing in the same direction and should be pointing towards the tab hole on the canopy. Refer to Figure 14.
Figure 14 - Rotating the fan
2.Hook the tab hole over the tab on the ceiling plate as shown in Figure 15.
Canopy |
|
Trim Ring | Tab |
Figure 16 - Canopy trim ring
2.Take both hands and push the canopy trim ring up to the top of the canopy. See Figure 16.
3.The canopy trim ring will snap and lock into place on the canopy.
removing the canopy trim ring
1.Locate the tab indicators, small bumps on top of tabs. Refer to Figure 17.
2.To remove the canopy trim ring, press firmly on opposite sides of the ring towards the canopy as shown in Figure 17. The tabs will flex out releasing the trim ring from the canopy.
Tab Indicator Canopy Trim Ring
Canopy
Figure 17 - Removing the canopy trim ring
© 2002 Hunter Fan Company |