INSTALLATION
UNPACKING
•Remove all packaging and dispose of it in a responsible manner.
•Open the
•Do not attempt to operate the machine while any of the packaging is still in place.
POSITIONING
•The machine should be installed in a well ventilated place, away from direct sunlight.
•Hot and cold water taps should be located within 1 metre of the inlet valves.
•Positioned the machine on a flat and stable uncarpeted floor capable of supporting the fully loaded washer.
•An adjustable levelling foot is located at the right front of the machine and may be turned in or out to achieve stability. An unstable machine will vibrate and generate excessive noise.
Drain outlet
DRAIN HOSE |
|
| |
• Connect the drain hose to the drain outlet at the rear |
|
| |
of the machine and secure it with the hose clamp |
|
| |
| Hose clamp | ||
supplied. | Drain hose | ||
| |||
• Hook the outlet end of the drain hose over the lip of a |
|
| |
sink or outlet pipe. |
|
|
A
SINK OR LAUNDRY TUB DRAIN
•The top lip of the sink must be at least 860mm (A) above floor level and not higher than 1300mm.
PIPE DRAIN | B |
•The minimum inside diameter of the pipe drain should be 30mm and the pipe should be able to drain 30 litres per minute.
•The top lip of the pipe should be at least 860mm
(B) above floor level and not higher than 1300mm.
