8 • Aligning the Fixture Fitter
8-1. Looking up at the bottom of the fan trim. Locate the raised arrow on the bottom of the trim. Before proceeding with the next step make sure you’ve located the arrow.
Note: You may have to rotate the fan blades in order to see the arrow.
8-2. The (8) sides of the fitter must be aligned with the matching (8) sides of the fan trim. To orient the fitter locate the (3) arrow shaped holes near the outer edges of the fitter.
8-3. Select the arrow which has a screw hole directly behind it, and align this arrow with the arrow in the trim.
8-4. Thread the upper plug connector from the motor through the large hole in the center of the fitter.
8-5. Check the (3) elongated slots in the top of the fitter to see if they are aligned with the (3) mating screw holes in the fitter mounting plate. If any of the screw holes in the mounting plate are covered by the fitter, rotate the fitter ninety degrees either direction to allow access to the (3) mounting holes in the mounting plate. Assemble the fitter to the fitter mounting plate using (3) 3/8” long Phillips head screws with lock washers. Tighten securely.
Elongated
Slots
Steps 8-4-8-5
13
Step 8-1
Fitter
Arrow Shaped Hole
Screw Hole
Step 8-2
41225-01 • 12/04/09 • Hunter Fan Company
