Hunter Fan 42797-01 installation manual Assembling and Hanging the Fan, Steps 4-4

Page 7

4 • Assembling and Hanging the Fan

Steps 4-14-2

Downrod

Canopy

Steps 4-44-5

Low Profile Washer

Low Profile Screw

You can assemble your fan for standard mounting (steps 4-14-2) or for low profile mounting (steps 4-34-5). Note: For low profile mounting, the downrod is replaced with the low profile washer.

4-1. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy. Feed the wires from the fan through the downrod.

4-2. Loosen the square head set screw on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the set screw with a wrench or pliers. Skip to Step 4-6.

CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.

4-3. Remove the set screw from the adapter.

4-4. Place the low profile washer (lip down) into the canopy. Be sure the green ground wire is pointing up toward the ceiling.

4-5. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws.

Note: Before hanging the fan, align and engage the two tabs from the bottom of the canopy and the two grooves in the hanger ball.

4-6. Raise the fan and place the hook on the ceiling plate through the round hole in the rim.

Step 4-6

Round

Hole

WARNING: Fan may fall if not assembled as directed in these installation instructions.

7

42797-01 • 11/13/08 • Hunter Fan Company

Image 7
Contents Type 3 Models Welcome Installer’s Choice and Optional Accessories Gathering the Tools Getting ReadyInstalling the Ceiling Plate Assembling the Top Housing Steps 4-4 Assembling and Hanging the FanSetting Transmitter and Receiver Codes Setting the Remote Transmitter and ReceiverWiring the Fan Wiring the Fan Installing the Canopy Assembling tbe Blades Assembling the Blades Completing Your Installation Operating the Remote Control and Mounting the Holder Operating and Cleaning Your Ceiling Fan Beat the High Cost of Cooling Problem Nothing happens fan does not move Troubleshooting