Hunter Fan 42845-01 Hanging and Wiring the Fan, Dual Switch Wiring, Single Switch Wiring

4 • Hanging and Wiring the Fan

Tab

Handle

Step 4-1

Wire

Connector

Dual Switch Wiring

Step 4-6 (Dual)

Single Switch Wiring

Step 4-6 (Single)

4-1. Lift the motor assembly and hook the three tabs over the handles, one at a time.

All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician.

Wall switches are not included. Select an acceptable general-use switch in accordance with national and local electrical codes.

4-2. Before attempting installation, make sure the power is still off.

4-3. To connect the wires, hold the bare metal leads together and place a wire connector over them, then twist clockwise until tight. For all these connections use the wire connectors provided.

4-4. Connect the bare or green ground wire (grounding) from the ceiling to the green ground wire (grounding) from the ceiling plate and the green ground wire from the fan.

4-5. Connect the white wire (grounded) from the ceiling to the white wire (grounded) from the fan.

4-6. Connect the remaining wires as follows:

Dual Switch Wiring:

•The black wire (ungrounded) from the ceiling to the black wire (ungrounded) from the fan

•The black/white wire (ungrounded) from the fan to the wire (ungrounded) for the wall switch

Single Switch Wiring:

•The black wire (ungrounded) from the ceiling to the black (ungrounded) and the black/white wire (ungrounded) from the fan

CAUTION: Be sure no bare wire or wire strands are visible after making connections.

4-7. Turn the splices upward and push them carefully back through the ceiling plate into the outlet box.

4-8. Spread the wires apart, with the grounded wires on one side of the outlet box and the ungrounded wires on the other side of the outlet box.

9

42845-01 • 02/16/10 • Hunter Fan Company