Hunter Fan 42508-01 installation manual Installing the Canopy and Canopy Trim Ring

5 • Installing the Canopy and Canopy Trim Ring

Note: Be sure the arrows on the downrod and on the ceiling plate are both pointing toward the tab hole on the canopy.

5-1. Hook the tab hole in the canopy over the tab on the ceiling plate.

5-2. Raise the canopy. Make sure the holes in the canopy and in the ceiling plate are aligned.

5-3. Partially install the three canopy screws into the canopy one at a time. Once all three screws are in, tighten them.

5-4. Using both hands, push the canopy trim ring up to the top of the canopy. The canopy trim ring will snap and lock into place.

Should you need to remove the canopy trim ring, follow these steps:

1.Locate the tab indicators, small bumps on top of tabs.

2.Press firmly on opposite sides of the

ring toward the canopy. The tabs will flex out releasing the trim ring from the canopy.

Canopy

Screw

Step 5-1

Tab

Tab Hole Canopy

Canopy

Trim Ring

Steps 5-2 – 5-3

Step 5-4

9

42508-01 • 09/23/08 • Hunter Fan Company