Hunter Fan 41897-01 manual Wiring the Fan

All wiring must be in accordance with national and local electrical codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a qualified electrician.

Wall switches are not included. Select an acceptable general-use switch in accordance with national and local electrical codes.

6-1. Disconnect the power by turning off the circuit breakers to the outlet box and associated wall switch location.

6-2. Decide how you want to set up the fan and light controls. You can control the fan and/or lights together or separately using one or two wall switches. Follow Step 6-3 OR Step 6-4, depending on what you decide.

6-3. If you want to, you can control the fan and light separately using two wall switches, connect the wires as follows:

•e bare or green ground wire from the ceiling to the green ground wire from the ceiling plate and the green ground wire from the fan

•e white wire from the ceiling to the white wire from the fan

•e black wire from the ceiling to the black wire from the fan

•e black/white wire from the fan to the wire for the wall switch

6-4. Alternatively, you can control both fan and light with one switch. To do so connect the wires as follows:

•e bare or green ground wire from the ceiling to the green ground wire from the ceiling plate and the green ground wire from the fan

•e white wire from the ceiling to the white wire from the fan

•e black wire from the ceiling to the black and the black/ white wire from the fan

6-5. To connect the wires, hold the bare metal leads together and place a wire nut over them, then twist clockwise until tight.

CAUTION: Be sure no bare wire or wire strands are visible after making connections.

6-6. Push all wires and wire nuts back through the ceiling plate hole into the outlet box.

6 • Wiring the Fan

Step 6-3

9

Step 6-4

Wire Nut

41897-01 • 11/22/05 Hunter Fan Company