Hunter Fan 42737-01 manual Step Steps 5-4, Detail, Steps 6-1

5 • Installing the Canopy and Canopy Trim Ring

6 • Assembling the Blades

Step 5-2 Ceiling Plate

Canopy	Canopy Trim
	Ring

8

Step 5-3

Steps 5-4 – 5-5

5-1. Holding the canopy, raise the fan off the hook.

5-2. Align the slots in the canopy with the tabs on the ceiling plate.

5-3. Raise the canopy over the ceiling plate. Rotate the canopy clockwise until the tabs on the ceiling plate totally engage with the slots in the canopy.

5-4. Partially install the three canopy screws into the canopy one at a time. Once all three screws are in, tighten them.

5-5. Using both hands, push the canopy trim ring up to the top of the canopy. The canopy trim ring will snap and lock into place.

Should you need to remove the canopy trim ring, follow these steps:

1.Locate the tab indicators, small bumps on top of tabs.

2.Press firmly on opposite sides of the ring towards the canopy. The tabs will flex out releasing the trim ring from the canopy.

Hunter fans use several styles of fan blade irons (brackets that hold the blade to the fan).

6-1. Your fan may include blade grommets. If your fan has grommets, insert them by hand into the holes on the blades.

6-2. Attach each blade to a blade iron using three blade assembly screws. If you used grommets, the blades may appear slightly loose after screws are tightened. This is normal.

6-3. Remove the blade mounting screws and rubber shipping bumpers from the motor. Note: Some blade mounting screws are installed in the motor to secure shipping blocks.

6-4. For each blade, insert one blade mounting screw through the blade iron, and attach lightly to the fan. Insert the second blade mounting screw, then securely tighten both mounting screws.

	Blade Assembly
Use with grommet	Screws

Use without grommet

Step 6-1 (Detail)

Grommet

Steps 6-1 – 6-2

9

Canopy Screw

Blade

Mounting

Screw

Step 6-4

Hunter Fan Company 42737-01 • 11/14/06 42737-01 • 11/14/06 Hunter Fan Company