Hunter Fan 45039-01 Assembling and Hanging the Fan, For Standard or Angled mounting

Page 6

3 • Assembling and Hanging the Fan

WARNING: Fan may fall if not assembled as directed in these installation instructions.

3-1. Unbundle the wires from the fan and remove the paper caution tag. Do not discard the tag until your installation is complete.

For Standard or Angled mounting:

3-2. To assemble fan to hang down from a flat or angled ceiling, insert the downrod through the canopy, adapter cover grommet, adapter cover, and canopy trim ring. (The adapter cover and adapter cover grommet may already be attached to make one piece.) Feed the wires from the fan through the downrod.

3-3. Loosen the square-head setscrew on the adapter to install the pipe and ball assembly. Note: When the pipe and ball assembly is fully installed, 2-3 threads on the pipe will still be visible; this is normal. Securely retighten the setscrew with a wrench or pliers. Skip to Step 4-7.

CAUTION: The adapter has a special coating on the threads. Do not remove this coating; the coating prevents the downrod from unscrewing. Once assembled, do not remove the downrod.

For Low Profile mounting:

Note: For low profile mounting, the downrod is replaced with the low profile washer. The adapter cover and adapter cover grommet are not used for low profile mounting.

3-4. Remove the set screw from the adapter.

3-5. Place the low profile washer into the canopy.

3-6. Align the holes in the washer with the holes in the adapter. Assemble securely with three low profile screws.

Hanging the Fan:

Note: To hang the fan, you must tilt the canopy to an almost vertical position so that the canopy slots sit on the ceiling plate hooks.

3-7. Raise the fan and align the slots in the canopy with the hooks on the ceiling plate.

3-8. Place the slots over the hooks to hang the fan.

Steps 3-23-3

Canopy

 

 

 

 

 

 

 

 

 

Downrod

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Adapter

 

 

 

 

 

Cover

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Grommet

 

 

 

Adapter

 

 

 

 

 

 

 

 

 

 

 

Canopy

 

 

 

 

 

 

Cover

 

 

 

 

 

Trim Ring

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Setscrew

 

 

 

 

 

 

 

 

 

 

 

 

Low Profile Washer

Steps 3-53-6

 

#8-32 x 1/2” Screw

6

45039-01 • 09/16/09 • Hunter Fan Company

Image 6
Contents Type 2 Models Welcome Installer’s Choice and Optional Accessories Installing Multiple Fans? Getting ReadyInstalling the Ceiling Plate Flat Washer Wood Screw Toward Ceiling PeakFor Low Profile mounting Assembling and Hanging the FanFor Standard or Angled mounting Hanging the FanWiring the Fan Dual Switch WiringSingle Switch Wiring Installing the Canopy and Canopy Trim Ring Assembling the Blades Housing Assembly Upper Screw Switch Steps 7-6 Installing the Glass Bowl Uninstalling the Light Fixture Operating and Cleaning Your Ceiling Fan To Change Airflow DirectionProblem Noisy operation TroubleshootingProblem Nothing happens fan does not move Problem Excessive wobbling