HoMedics WFL-FLOR instruction manual Assembly and Instructions for Use, Minimum Water Level

Assembly and Instructions for Use

1.Unpack the product. Wipe off dust with a damp cloth.

2.Familiarize yourself with the pump. The pump speed is controlled by the switch located at the front of the pump. The speed is indicated by a plus (+) and minus (-) sign. To increase the speed, move the switch slowly to the left in the direction of the plus sign. You will hear a click as the switch moves to each speed level. At its highest speed level, the switch will cease to move any further. To decrease the pump speed, move the switch to the right toward the minus sign. Similarly, at its lowest speed, the switch will cease to move any further. (Fig 1)

NOTE: It is recommended the pump be set at its highest speed during assembly and later adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting the speed setting.

6.Fill the base with clean water until the water level reaches top of light clip, approximately 24 oz. (Fig. 3)

7.Place the screen on the base. (Fig. 5)

8.Attach the Adaptor to the power cord. (Fig. 5)

9.Plug the cord into 120V household outlet. The fountain is controlled by a switch located on the power cord. If pump does not operate, rotate in-line switch once to turn “on” and once to turn “off”.

Note: Ensure that the electrical cord loops below the electrical outlet to form a “Drip Loop”. This will prevent water from running down the electrical cord into the electrical outlet. (Fig. 6)

Attention:

In order to get best results, please operate pump completely submerged. Keep the water level above the minimum water level ALL THE TIME.

Figure 1

Minimum Water Level

Flow Control Lever

(+) faster water output

(-) slower water output

Figure 4

	Top
	Back of
	Top
Base	Notch

3.Insert the black connector at the bottom of the plastic tube attached to the foun- tain top into the round opening of the pump. (Fig. 2)

4.Insert waterproof light B into the light clip located inside the base (Fig. 3). Lights should be facing upwards within light clip.

5.Align the notches located on the bottom of fountain top with tabs located on base. Attach by moving from front to back (Fig. 4).

Note: Run the plastic tube into the base through the slot at the back of the base.

Tab

Base

Figure 5

Figure 2

Top

Middle

Tier

Waterproof

Light A

Plastic

Tube

Pump

Waterproof Light B

Figure 3

	Top
	Water
	Base
Waterproof
Light B	Light Clip
4

	Top
Screen	Switch
	Power Cord
	Adaptor
Base

5