1BHFPG

Lighting Systems LSBW-2

-ZUFTQSFBEÜ-4#4PMJE8BMM.PVOU-JHIU51FS'PPU /PNJOBM 4FDUJPO

11-3/8" (28.89cm)

8-1/2" (21.59cm)

3-1/2" (8.89cm)

1-3/4"

(4.45cm)

Ordering Information

TypeLampsLength

LSBW		2
	2 = 2-Lamp T5		4 = 4-Foot
			8 = 8-Foot

Complete ordering instructions below.

ShieldingBallastVoltageFinish

A = Solid	28 = 28W T5	1 = 120 Volt	AL = Aluminum
	54 = 54W T5	2 = 277 Volt	WH = White
	5E = 54W T5 Emergency Pack
	2E = 28W T5 Emergency Pack
	5D = 54W T5 Dimming

Features

1.Housing: Extruded aluminum. Die-cast end cap mechanically attached with no exposed fasteners or hardware.

2.Lamping: Two T5, 28 or 54 watt (as specified) fluorescent lamps per 4-foot nominal section. Provided by others.

3.Reflector: Precision die-formed, semi-specular aluminum.

Electrical

Ballast - <10% T.H.D., .98 ballast factor, pre-heat start. 18 gauge wire. Color- coded quick connectors allow ease of connection for joiner modules. For special circuiting, consult factory. Factory installed ballast disconnect allows the ballast to be disconnected from and reconnected to incoming power under load without turning the entire circuit off.

Dimming - 120/277 VAC, 1% dimming level.

Emergency Battery Pack - 28 Watt: 520 Lumens @ 90 min. 54 Watt: 700 Lumens @ 90 min.

Mountings

Dual-screw, draw-tight connector to create hairline seam between joiner modules.

Finish

Powder coated baked white or aluminum finish.

Custom colors available, consult factory.

Labels

UL, cUL and I.B.E.W.

Ordering Instructions

Individual Fixtures:

1.Order number of MODULES required.

2.Order one END SET per MODULE.

Continuous Rows:

1.Determine run length.

2.Order the appropriate number of MODULES to complete the run.

3.Order one END SET per run.

Job Information

Type:

Job Name:

Cat. No.:

Lamp(s):

Notes:

"JSQPSU3PBE'BMM3JWFS."t t'BY

We reserve the right to change details of design, materials and finish.

XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt #