Samsung HT-D5100/EN, HT-D5100/XN, HT-D5100/ZF, HT-D5100/XE manual FM ANT Component OUT Speakers OUT

Connections

!CAUTION

Do not insert any other card except the TX card dedicated to the product.

If a different TX card is used, the product may be damaged or the card may not be removed easily.

Do not insert the TX card upside down or in the reverse direction.

Insert the TX card when the product is turned off. Inserting the card when it is turned on may cause a problem.

The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.

For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.

If no sound is heard from the wireless surround speakers, switch the mode to Dolby Pro Logic II.

In 2-CH mode, no sound will be heard from the wireless surround speakers.

✎NOTE

Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the product, some sound interruption may be heard due to interference.

If you use a device such as a microwave oven, wireless LAN Card or any other device that uses the same frequency (2.4/5.8GHz) near the product, some sound interruption may be heard due to interference.

The transmission distance from the product to the wireless receiver module is about 10m, but may vary depending on your operating environment. If a steel-concrete wall or metallic wall is between the product and the wireless receiver module, the system may not operate at all, because the radio wave cannot penetrate metal.

If the product doesn't make wireless connection, the system needs ID Setting between the

product and wireless receiver module. With the main unit turned off, press the remote control's "0""1""3""5" number buttons and then turn on the unit. With the wireless receiver module

turned on, press "ID SET" button on the back of the wireless receiver module for 5 seconds. And then power on the product (HT-D5100).

Attaching the Toroidal Ferrite Core to the Power Cord of the Main Unit

If you attach a Toroidal ferrite core to the power cord of the man unit, it will help to prevent RF interference from radio signals.

1.Pull the fixing tab of the Toroidal ferrite core to open it.

2.Make a loop twice in the main unit power cord.

3.Attach the Toroidal ferrite core to the main unit power cord as the figure shows and press it until it clicks.

FM ANT	COMPONENT OUT		SPEAKERS OUT
			CENTER	FRONT	SURROUND
			SUBWOOFER	FRONT	SURROUND
WIRELESS	AUX IN	VIDEO OUT	SPEAKER IMPEDANCE : 3

20 English

HT-D5100_ELS_1224.indd 20 2011-12-24 ￿￿ 10:03:28