Basic Functions
How to Link the Wireless Transmitter
with the Main Unit
1.Turn off your Home Cinema.
2.Press the 4, 7, 6, 3 buttons on the remote control in order.
•The Power LED blinks once.
3.Connect the iPod/iPhone to the Wireless transmitter.
L
INK
STANDBY
CHARGE
4.Turn on the iPod/iPhone. Press the "ID SET" button on the back of the Wireless transmitter for 5 seconds. The link light on the wireless transmitter blinks rapidly.
5.Turn on your product.
•To listen to music from iPod/iPhone over the
product, press the 
button to select "W. IPOD" mode.
•After you select "W. IPOD" mode, turn the volume of the product down to avoid hearing damage.
•You can control the speaker volume of iPod/ iPhone with a volume wheel or a volume bar.
•When iPod/iPhone is stopped or in a power saving mode, the Wireless transmitter enters Sleep Mode.
When iPod/iPhone is set to Deep Sleep
Mode, the Wireless transmitter turns off.
Operation status of the wireless transmitter's LED
LINK |
|
| |
| STANDBY |
| |
| LINK |
| |
| STANDBY |
| |
| CH |
| |
| ARGE |
| |
| Function | ||
Display | LINK | STANDBY | |
| |||
| (Blue LED) | (Red LED) | |
| Pairing |
| |
LED ON | successfully | STANDBY | |
| completed |
| |
LED BLINK | Processing iPod/ | LOW BATTERY | |
(Long blink) | iPhone | ||
| |||
LED BLINK | Processing | Pairing failed | |
(Short blink) | pairing | ||
| |||
!CAUTION
If you use the main unit near a wireless device such as a laptop computer, an AP, or Wifi, an unstable operation error can occur.
Do not pair the
The transmission distance from the product to the wireless transmitter is about 5 meters, but may vary depending on your operation environment.
The audio signal may be weakened or even lost where there is an obstacle such as a wall or partition between the product and wireless transmitter. You can also weaken or lose signal