Connectingthe Antennas
FM antenna connection
FM Antenna (supplied)
1 | Connect the FM antenna supplied to the FM 75Ω COAXIAL terminal as a | |
| ||
2 | temporary measure. | |
Slowly move the antenna wire around until you find a location where | ||
| ||
| reception is good, then fasten it to a wall or other rigid surface. |
• If reception is poor, connect an outdoor antenna. Before attaching a 75Ω coaxial cable (with a standard type connector), disconnect the supplied FM antenna.
AM(MW) antenna connection
If AM reception is poor, connect an outdoor | 1 | 2 | 3 | CONNECTIONS |
|
|
| ||
AM antenna(not supplied). |
|
|
| |
|
|
|
| |
AM Loop Antenna |
|
|
|
|
(supplied) |
|
|
|
|
Snap the tabs on the loop into the |
|
|
|
|
slots of the base to assemble the |
|
|
|
|
AM loop antenna. |
|
|
|
|
1 Connect the AM loop antenna supplied to the AM and terminals.
2 | If reception is poor, connect an outdoor single |
| |
| terminal. (Keep the AM loop antenna connected). |
Cooling Fan | The cooling fan dissipates the heat generated inside the unit so that the unit can be operated | |
normally. The cooling fan is activated automatically to supply cool air to the unit. | ||
| ||
| Please observe the following cautions for your safety. | |
| • Make sure the unit is | |
| and may damage it. | |
| • Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a | |
| newspaper or cloth, heat may build up inside the unit and fire may result.) |
17 | 18 |