Connecting External Components
Connecting the FM and AM Antennas | GB |
|
Connecting an External Digital / Analog Component
Example: Digital signal components such as a
Analog signal components such as a VCR or TV.
Audio Cable |
|
(not supplied) |
|
If the external analog |
|
component has only one | Optical Cable |
Audio Out, connect either left | (not included) |
or right. |
|
If AM reception is poor, connect an outdoor AM antenna(not supplied).
FM Antenna (supplied)
FM antenna connection
AM Loop Antenna (supplied)
Snap the tabs on the loop into the slots of the base to assemble the AM loop antenna.
AM antenna connection
CONNECTIONS
1 Connect the Digital Input (OPTICAL) to the Digital Output on the external digital component.
2 Connect Audio In on the Home Theater to Audio Out on the external analog component.
•Be sure to match connector colors.
3 Press AUX on the remote control to select ‘DIGITAL IN / AUX 1 / AUX 2’ input.
1.Connect the FM antenna supplied to the FM 75Ω COAXIAL terminal.
2.Slowly move the antenna wire around until you find a location where reception is good, then fasten it to a wall or other rigid surface.
1.Connect the AM loop antenna supplied to the AM and terminals.
•Insert the black wire into the black terminal and the white wire into the white terminal.
2.If reception is poor, connect an outdoor single
•Each time the button is pressed, the selection changes as follows: DIGITAL IN ➝ AUX 1 ➝ AUX 2.
•You can also use the FUNCTION button on the main unit.
The mode switches as follows: DVD/CD ➝ DIGITAL IN ➝ AUX 1 ➝ AUX 2 ➝ FM ➝ AM.
Cooling Fan | The cooling fan supplies cool air to the unit to prevent overheating. |
Please observe the following cautions for your safety.
• Make sure the unit is
• Do not obstruct the cooling fan or ventilation holes. (If the cooling fan or ventilation holes are covered with a newspaper or cloth, heat may build up inside the unit and fire may result.)
17 | 18 |