Connecting Wireless Rear Speakers
GB
Resetting Wireless Communication
1Connect your pair of wireless rear speakers, (L) and (R), to the wireless receiver module.
2Connect the power cord of the wireless receiver module to the wall outlet and turn the power "ON".
• The Power Standby indicator will light up.
Reset the system if a communication failure occurs, or if the synchronizing signal indicator does not light up and the "REAR CHK" message blinks on the main unit's display.
Reset the system while the main unit and the wireless receiver module
Wireless Rear Speaker (R) | Wireless Rear Speaker (L) |
GrayBlue
Back of Wireless receiver module
Caution
1 With the main unit turned off, press and hold the remote control's REMAIN button for 4 seconds.
•Press the button until the volume control indicator lights up blue. (The indicator will turn off in 1 second.)
2 With the wireless receiver module turned on, use a ball point pen or a pair of tweezers to press the RESET button
RESET Button
Back of Wireless receiver module
CONNECTIONS
•Do not connect the wireless rear speakers to the speaker outputs on the back of the main unit. Malfunction may result.
•The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and moisture.
•For optimal listening performance, make sure that the area around the wireless receiver module location is clear of any obstructions.
To hang the wireless receiver module on the wall
on the back of the unit 2 to 3 times.
•The Standby/On LED on the front panel of the wireless receiver module blinks 3 times.
3 Turn on the main unit.
• The Link LED of the wireless receiver module is lit and the setup is finished.
• If Power Standby mode continues, repeat Steps 1 to 3 above.
1Separate wireless receiver module stand.
3 Fix the wireless receiver
Fit the speaker
module on the wall. | hole onto the screw | |
• | Fix the wireless receiver | on the wall to hang |
(mount) the speaker. |
module firmly to prevent it from falling.
13
2Fasten the screws (not supplied) on the wall.
Note |
•Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to the main unit, some sound interruption may be heard due to interference.
•If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that uses the same frequency (2.4GHz) near the system, some sound interruption may be heard due to interference.
•The transmission distance of radio wave is about 33 feet, but may vary depending on your operating environment. If a
Caution
•Sound will be heard from the wireless rear speakers in DVD
•In
14