Samsung HT-DS400 manual Setting the Speaker Mode, Setting the Test Tone, Press Test Tone button

Setting the Speaker Mode

Signal outputs and frequency responses from the speakers will automatically be adjusted according to your speaker configuration and whether certain speakers are used or not.

Setting the Test Tone

Press the Test Tone to check the speaker connections and to adjust the speaker levels.

In Stop mode,

1 press MENU

button.

Press Cursor 2 button to move to

‘Audio’ and then press ENTER button.

Press Cursor , ,

In Stop mode,

1 press MENU button.

Press Cursor 2 button to move to

‘Audio’ and then press ENTER button.

Press Cursor button

3 to move to ‘TEST TONE’ and then press ENTER button.

•The test tone will be sent to L ➝ C ➝ R ➝ RS ➝ LS ➝ SW in that order.

If the ENTER button is pressed again at this time, the test tone will stop.

In the Speaker

3 Setup, press the ENTER button again.

4 , buttons to move to the desired speaker and then press ENTER button.

•For C, LS, and RS, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.

•For L and R, the mode is set to SMALL.

Press RETURN button to return to the previous level. SETUP

Press MENU button to exit the setup screen.

SMALL : Select this when using the speakers.

NONE : Select this when no speakers are installed.

Note

•Depending on PRO LOGIC and STEREO, the speaker mode may vary.

53

When manually testing using the TEST TONE button

Press TEST TONE button.

•Test tone will be produced as follows: When playing a DVD or CD, this will work only in Stop mode.

•Use this function to check that each speaker is correctly connected and that there is no problem.

To end the test tone, press TEST TONE button.

L: Front Speaker (L)	C: Center Speaker	SW: Subwoofer
R: Front Speaker (R)	LS: Rear Speaker (L)	RS: Rear Speaker (R)

Multi-Channel Pro Logic Mode

Start

54