Samsung HT-DM150, HTDM150RH/ELS manual Setting the Speaker Mode Setting the Test Tone, Enter button

Setting the Speaker Mode

Setting the Test Tone

1 Press MENU button.

Press Cursor 2 button to move to

‘Audio’ and then press ENTER button.

Press Cursor , ,

Press Cursor

12 button to move to Press MENU button.

‘Audio’ and then press ENTER button.

3	Press Cursor button
	to move to ‘TEST
	TONE’ and then press
	ENTER button.

•The test tone will be sent to L ➝ C ➝ R ➝ RS ➝ LS ➝ SW in that order. If the button is pressed again at this time, the test tone will stop.

In the Speaker

3 Setup, press the ENTER button again.

, buttons to move 4 to the desired

speaker and then press ENTER button.

•For C, LS, and RS, each time the button is pressed, the mode switches alternately as follows: SMALL ➝ NONE.

•For L and R, the mode is set to SMALL.

Press RETURN button to return to the previous level. SETUP

Press MENU button to exit the setup screen.

45

SMALL : Select this when using the speakers.

NONE : Select this when no speakers are installed.

Note

• With (Dolby Pro Logic II), the delay time may be different for each mode.

• With AC-3 and DTS, the delay time is set between 00 and 15mSEC.

• Depending on PRO LOGIC and STEREO, the speaker mode may vary.

When manually testing using the TEST TONE button

Press TEST TONE button.

•Test tone will be produced as follows: When playing a DVD or CD, this will work only in Stop mode.

•Use this function to check that each speaker is correctly connected and that there is no problem.

To end the test tone,

press TEST TONE button.

L: Front Speaker (L)	C: Center Speaker	SW: Subwoofer
R: Front Speaker (R)	LS: Rear Speaker (L)	RS: Rear Speaker (R)

Multi-Channel Pro Logic Mode

Start

46