MENU | DESCRIPTION |
|
|
PC | For PC signals, the four PC functions eliminate or reduce noise that causes unstable screen quality, |
| such as screen shaking. If the noise is not removed using Fine Adjustment, adjust the frequency to |
| the maximum and then perform Fine Adjustment again. |
| These functions are only enabled for the PC Timing |
| Refer to PC Timing |
| • <Auto Adjustment> : Used to adjust the frequency and phase of PC screen automatically. |
| • <Coarse> : Used to adjust the frequency when vertical lines appear on the PC screen. |
| • <Fine> : Used to fine tune the PC screen. |
| • <Reset> : Using this function, you can reset the PC menu settings to the factory default settings. |
|
|
Zoom | You can magnify the screen to a size you want. |
| • <x1> - <x2> - <x4> - <x8> |
| This function is only enabled when the input signal is a PC Timing |
|
|
3-5-3. Setup
MENU |
| DESCRIPTION |
|
| |
Install | To tailor the picture to the installation location, (for example, behind a | |
| ing from the ceiling), you can invert the projected images vertically / horizontally. | |
| • | |
| • | |
| • | |
| • | |
|
| |
Lamp Mode | Using this function, you can set the image brightness by adjusting the amount of light generated by | |
| the lamp. | |
| • <Eco> : This mode is optimized for screens smaller than 100 inches. | |
|
| This mode decreases the lamp brightness and power consumption in order to extend the lamp |
|
| lifetime and reduce noise and power consumption. |
| • <Bright> : This mode maximizes the lamp brightness when the ambient illumination is bright. As | |
|
| the brightness of the lamp increases, the lamp lifetime can be reduced and the noise and power |
|
| consumption may increase. |
|
| |
Auto Keystone | If video scenes are distorted or tilted, you can compensate for this by setting the <Auto Keystone> | |
| function to <On> so that the | |
| • | |
|
|
|
Using |