Menu Position | You can move Menu Position up/down/left/right. | |
Menu | You can set the translucency of menu. | |
Translucency |
|
|
| 1) | Opaque |
| 2) | Low |
| 3) | Medium |
| 4) | High |
Menu Display You can set the display time of the menu.
Time
1) | 5 sec | 5) | 90 sec |
2) | 10 sec | 6) | 120 sec |
3) | 30 sec | 7) | Stay On |
4) | 60 sec |
|
|
LED Indicator This function turns the LEDs On or Off. If the LEDs are affecting the brightness of the LCD, you can turn all the LEDs off by turning off this function. Turning the function on again will allow the LEDs to operate properly again according to the status of the projector.
1)Off : This mode disables the operating LED. However, the LED will come on regardless of the LED setting when the power is turned on or off or when the projector is in an abnormal state.
2)On : This mode enables the operating LED so that it can display the current operating state of the projector.
Light Effect You can turn the LED indicators on your projector on or off according to your requirements.
1)Off : LED will not come on.
2)In Standby : Turns the LED on in standby mode.
3)In Watching TV : Turns the LED on while watching TV.
4)Always : LED will come on after you turn the TV off.
Appears as an ellipse at the top at the back of your projector.
Blue sreen The Blue screen function causes the screen to change to the Blue screen if there is no signal input from the external device connected to your projector.
1)Off
2)On
Information You can check external source signals, picture setup, PC picture adjustment and lamp use time.