Samsung HW-K360/EN, HW-K360/ZF manual Connecting the Subwoofer and the SWA-8000S Sold Separately

CONNECTIONS

●● Before moving or installing the product, be sure to turn off the power and disconnect the power cord. ●● If you use a device that uses the same frequency (2.4GHz) as the Soundbar near the Soundbar,

interference may cause some sound interruption.

●● The maximum transmission distance of the wireless signal between the main unit and subwoofer is about 5 m, but may vary depending on your operating environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all because the wireless signal cannot penetrate metal.

●● If the main unit doesn't make a wireless connection, repeat steps 1-6 starting on the previous page to re-set the connection between the main unit and wireless subwoofer.

●● The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture.

●● For optimal listening performance, make sure that the area around the wireless subwoofer location is clear of any obstructions.

Expand to true wireless surround sound by connecting the Samsung Wireless Rear Speaker Kit (SWA-8000S) to your Soundbar. (Sold separately)

CONNECTING THE SUBWOOFER AND THE SWA-8000S (SOLD SEPARATELY)

CONNECTING THE SUBWOOFER AND THE SWA-8000S (SOLD SEPARATELY) MANUALLY

If the blue LEDs do not stop blinking when the main unit, subwoofer, and SWA-8000S are turned on, please reset the linking ID by following the procedure below.

L R

SURROUND SPEAKERS OUT

SPEAKER IMPED

ID SET

1. Plug the power cords of the main unit, subwoofer and the SWA-8000S into an AC wall outlet.

2. Press the ID SET button on the back of the subwoofer and the SWA-8000S with a small, pointed object for 5
	seconds.
3.	• The LINK indicators (Blue LEDs) on the subwoofer and the SWA-8000S blink quickly.
	Press the	button on your remote control for 5 seconds while the main unit is turned OFF.
4.	The ID SET message appears on the display of the main unit for a short period of time, and then disappears.
5.	While the subwoofer's and the SWA-8000S's indicators are blinking blue, press the		button on your remote control or
6.	on the right side of the main unit to turn on the main unit.
	The connection is complete if the blue LEDs on the subwoofer and the SWA-8000S stop blinking and glow
	continuously.	18