Samsung HW-D450/EN, HW-D450/XN, HW-D450/ZA manual COnneCTing THe WireLeSS SUBWOOfer, Standby Link

COnneCTing THe WireLeSS SUBWOOfer

The Subwoofer's linking ID is preset at the factory and the main unit and sub should link (connect wirelessly) automatically when main unit is turned on. If the link indicator does not light when main unit and subwoofer are turned on, please set the ID by following the process below.

1.Plug the power cords of the main unit and subwoofer into an AC power supply.

2.Press the iD SeT button on the back of the subwoofer with a small, pointed object for 5 seconds.

• The STANDBY indicator is turned off and the LINK indicator (Blue LED) blinks quickly.

▪ Before moving or installing the product, be sure to turn off the power and disconnect the power cord.

▪If the main unit is powered off, the wireless subwoofer will be in the standby mode and the STANDBY LED on the upper side will come on after 30 seconds Link indicator (Blue LED) blinking.

▪If you use a device that uses the same frequency (5.2GHz or 5.8GHz) near the system, some sound interruption may be heard due to interference.

▪The transmission distance of the wireless signal between the main unit and sub is about 33 ft., but may vary depending on your operating environment. If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all, because the wireless signal cannot penetrate metal.

▪If the main unit doesn't make wireless connection, follow steps 1-4 above to retry the connection between the main unit and wireless subwoofer.

▪ The wireless receiving antenna is built into the wireless subwoofer. Keep the unit away from water and moisture.

▪For optimal listening performance, make sure that the area around the wireless subwoofer location is clear of any obstructions.

1