Samsung NZ63K7777BK/EF manual Safety shutoff Flex zone Plus

Page 14

Parts and features

Safety shutoff

Flex zone Plus

If one of the cooking zones is not switched off or the heat setting is not adjusted after an extended period of time, that particular cooking zone will automatically switch itself off.

Any residual warmth will be indicated with , (for “hot”) in the digital displays corresponding to the particular cooking zones.

The cooking zones switch themselves off at the following times.

Heat setting

Switch off

 

 

1-3

After 6 hours

 

 

4-6

After 5 hours

Cooking Zone 1

Cooking Zone 2

Cooking Zone 3

The Flex zone is the large cooking area located on the left side of the hob (see the figure below) that is specially designed to accommodate multiple pots and pans of varying shapes and sizes at once. The Flex zone has four zones that are operated by individual inductors, allowing you to cook regardless of where cookware is placed on a cooking zone.

Parts and features

7-9

After 4 hours

 

 

10-15

After 1.5 hours

NOTE

If the Hob is overheated because of abnormal operation, will be displayed. And the Hob will be switched off.

NOTE

If cookware is unsuitable or too small or no cookware has been placed on the cooking zone, will be displayed.

And after 1 minute the corresponding cooking zone will be switched off.

NOTE

Should one or more of the cooking zones switch off before the indicated time has elapsed, see the section “Troubleshooting”.

Other reasons why a cooking zone will switch itself off

All cooking zones will switch themselves off if liquid boils over and lands on the control panel.

The automatic shutoff will also be activated if you place a damp cloth on the control panel. In both of these instances, the appliance will need to be switched on again using the main On/Off control sensor after the liquid or the cloth has been removed.

14  English

Cooking Zone 4

With Flex zone Plus, you can use a combination of different cooking zones to enlarge the cooking area. See the table below for the corresponding sensor to touch to activate the different combinations.

Cooking Zone 1 burner

2 burner

3 burner

4 burner

1

2

3

4

NOTE

When using only one cooking zone, the diameter of the bottom of the cookware must be less than 14 cm.

The hob may take 5-10 seconds to recognize the position of cookware.

Noises may occur while the hob recognizes the cookware.

Do not remove cookware during cooking. For safety purposes, the hob automatically stops if cookware has been removed for more than 5 seconds.

NZ63K7777BK_EF_DG68-00788A-00_EN.indd 14

2/18/2016 12:43:58 PM

Image 14
Contents Induction Hob Contents Using this manual Safety instructionsSafety instructions Safety instructions Disposing of the packaging material Proper disposal of your old applianceInstalling the hob Safety instructions for the installerConnecting to the mains power supply Installing into the countertop Hob Parts and features Cooking zonesControl panel Components Induction heatingKey features of your appliance Safety shutoff Flex zone Plus Virtual flame technology Residual heat indicatorTemperature detection Cookware for induction cooking zones Initial cleaningHob use Suitability testUsing suitable cookware Operating noisesSelect cooking zone and heat setting Using the touch control sensorsSwitching the appliance on Quick stop Switching the appliance offUsing the child safety lock Timer Count down Power boost control Timer Count upUsing keep warm Flex control Power managementPause Suggested settings for cooking specific foods Sound on/offLight soiling Cleaning and careHob Stubborn soiling To avoid damaging your appliance Problem dirtHob frame option Warranty and service FAQs and troubleshootingService Technical data Product informationMemo 18/2016 124403 PM Memo Questions or COMMENTS?
Related manuals
Manual 96 pages 50.52 Kb