CHECKING THAT YOUR OVEN IS OPERATING CORRECTLY
The following simple procedure enables you to check that your oven is working correctly at all times.
Open the oven door by pulling the handle on the right side of the door. Place a glass of water on the turntable. Then, close the door.
1. Press the Microwave button.
Result: The 800 W (maximum cooking power) indications are displayed.
2.After press the Dial Knob (800 W), set the time 4 to 5 minutes by turning the Dial Knob and press the
START/+30s button.
Result: The oven light comes on and the turntable starts rotating.
1)Cooking starts and when it has finished the oven beeps 4 times.
2)The end reminder signal will beep 3 times (once every minute).
3)The current time is displayed again.
The oven must be plugged into an appropriate wall socket. The turntable must be in position in the oven. If a power level other than the maximum is used, the water takes longer to boil.
SETTING THE TIME
Your microwave oven has an inbuilt clock. When power is supplied, “:0”, “88:88” or “12:00” is automatically displayed on the display.
Please set the current time. The time can be displayed in either the
•When you first install your microwave oven
•After a power failure
Do not forget to reset the clock when you switch to and from summer and winter time.
1. Press the Dial Knob.
To display the time in the...
24-hour notation.
2.Turn the Dial Knob to set time display type. (24H or 12H). At that time, press the Dial Knob to select the type of time.
3. Turn the Dial Knob to set the hour. At that time, press the Dial Knob to set the hour.
4.Turn the Dial Knob to set the minute.
5.Press the Dial Knob to complete the setup.
English - 14
��
11:14:24