Samsung RS21HKLFH1/XSV Installing the Water Dispenser Line, Connecting to the water supply line

Page 11

CHECKING THE WATER DISPENSER LINE (OPTIONAL)

A water dispenser is just one of the helpful features on your new Samsung refrigerator. To help promote better health, the Samsung water fi lter removes unwanted particles from your water. However, it does not sterilize or destroy microorganisms. You will need to purchase a water purifying system to do that. In order for the icemaker to operate properly, water pressure of 138 ~862 Kpa is required. Under normal conditions, a 170 cc paper cup can be fi lled in 10 seconds. If

the refrigerator is installed in an area with low water pressure (below 138 Kpa), you can install a booster pump to compensate for the low pressure. Make sure the water storage tank inside the refrigerator is properly

filled. To do this, press the water dispenser lever until the water runs from the water outlet.

Water Line installation Kits are included. You can fi nd it in one of the freezer drawers.

The new hose-sets supplied with the appliance are to be used and that old hose- sets should not be reused.

INSTALLING THE WATER DISPENSER LINE

For Interior model

Parts for water line Installation

2 Pipe connector

1Water line fixer and

screws

3 Water line

4 Water Filter

 

Connecting to the water supply line

1.First, shut off the main water supply line.

2.Locate the nearest cold, drinking water line.

3.Follow the water line installation instructions in the installation kit.

CAUTION

The water line must be connected to the cold water pipe. If it is connected to the hot water pipe, it may cause the purifier to malfunction.

4.After connecting the water supply to the water filter, turn your main water supply back on and dispense about 1l to clear and prime the water filter.

Close Main

Water pipe

Close Main

Water pipe

01

No gapSETTING UP

Connecting the water line to the refrigerator

1.Remove the dust cap from the water line on the rear of the unit and fit a compression nut from the install kit.

2.Remove the water pipe from the install kit and fit a compression nut to one end.

3.Join the two pipes together using the compression joint from the install kit ensuring that the joint is water tight.

4.Join the other end of the install pipe to the main water supply and turn on the water to check for leaks.

 

Remove

Loosen a

cap

 

Water Line

from unit

Water Line

from Kit

No gap

Only connect the water line to a drinkable water source. If you have to repair or disassemble the water line, cut off 6.5mm of the plastic tubing to make sure you get a snug, leak-free connection.

Before being used, the leakage in these CAUTION places should be examined.

setting up _11

DA99-02028A (EN)-11.indd 11

2014. 7. 14. ￿￿ 10:13

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Refrigerator Safety Information Safety informationMay fall and cause personal injury and/or material damage Severe Warning SignsCE Notice Shocks caused by current leakage from the refrigeratorHow long it is going to last CleaningAdditional Tips for Proper Usage Pipes shall be broke in the open spaceContents Straight out and push back in straight after fi nishing Setting up your side-by-side refrigeratorGetting Ready to Install the Refrigerator Selecting the best location for the refrigeratorRemoving the freezer door Removing the Refrigerator DoorsRemoving the Front Leg Cover Separating the Water Supply Line from the RefrigeratorReattaching the Freezer Door Reattaching the Refrigerator DoorsRemoving the Fridge Door Reattaching the Front Leg Cover Reattaching the Fridge DoorLevelling Refrigerator Making Minor Adjustments to the DoorsWhen the Freezer door is lower than the fridge When the Freezer door is higher than the fridgeNo gap Setting UP Installing the Water Dispenser LineFor Interior model Parts for water line Installation Connecting to the water supply lineWarranty Information For Exterior model Parts for water line InstallationFlush filter for 5 minutes before use Replacement InstructionsAttach the purifier lock-clip Secure the purifier in positionSecure the water line Using the anti-sweat heater switchConnect the water line to the refrigerator Check the amount of water supplied to the ice trayOperating Refrigerator Operating the Samsung side-by-side refrigeratorDispensing ice Controlling TemperatureUsing the ICE and Cold Water Dispenser Using the Water DispenserClose the water valve Using the Coolselect Zone Drawer OptionalQuick Cool ThawCool Removing the Freezer AccessoriesSoft Freeze Zero Zone 0ºCReplacing the Interior Light Removing the Fridge AccessoriesCleaning the Refrigerator For LED lamp, please contact service engineer to replace itTo reduce risk of water damage to your Using the DoorsOrdering replacement filters Changing the Water FilterTroubleshooting Memo Memo Contact Samsung World Wide Ambient Room Temperature Limits
Related manuals
Manual 2 pages 51.45 Kb Manual 24 pages 47.36 Kb Manual 2 pages 51.45 Kb Manual 4 pages 9.04 Kb Manual 14 pages 42.15 Kb Manual 2 pages 42.56 Kb Manual 32 pages 37.17 Kb Manual 24 pages 35.58 Kb Manual 2 pages 14.46 Kb Manual 276 pages 63.91 Kb Manual 64 pages 55.69 Kb Manual 4 pages 9.04 Kb Manual 1 pages 26.59 Kb

RS21HKLMR1/XSV, RS21HDLMR1/XSV, RS21HKLPM1/XSV, RS21HKLFH1/XSV, RSH5TERS1/XEF specifications

The Samsung RS22HZNBP1/XSV and RS21HKLMR1/XSV are two prominent models in the realm of modern refrigeration, boasting a host of advanced features and innovative technologies designed to enhance user convenience and food preservation.

The RS22HZNBP1/XSV is a stylish side-by-side refrigerator that blends aesthetic appeal with practicality. One of its defining features is the Twin Cool System, which employs two separate cooling systems for the refrigerator and freezer compartments. This ensures optimal humidity and temperature control, preventing the mixing of odors and preserving the freshness of food items. The model also includes a built-in Ice Maker, which provides a steady supply of ice without taking up extra space in the freezer.

Another key technology in the RS22HZNBP1/XSV is the Food Showcase feature, which optimizes usability by providing easy access to frequently used items. The outer doors open to reveal a sleek compartment for essentials like snacks and drinks, while the main section contains larger items, making organization effortless.

On the other hand, the RS21HKLMR1/XSV offers a more traditional design but packs a punch with its impressive functionality. This model features a spacious interior, capable of accommodating large groceries efficiently. The Digital Inverter Compressor is a standout element, adjusting its speed based on internal temperature, which enhances energy efficiency and reduces noise levels.

Both models come equipped with LED lighting, which not only illuminates the interior space but also uses less energy than traditional bulbs. This allows for better visibility, making it easier to find what you are looking for. Additionally, the Moister Control feature in both models helps to regulate humidity levels, preserving fruits and vegetables for longer periods.

Safety is paramount, with both models featuring a comprehensive antibacterial coating that inhibits the growth of harmful bacteria, ensuring a healthy food storage environment. Furthermore, the sleek exterior finishes of these refrigerators, available in different colors, allow them to blend seamlessly into any kitchen decor.

In summary, the Samsung RS22HZNBP1/XSV and RS21HKLMR1/XSV represent the pinnacle of modern refrigeration, prioritizing efficiency, technology, and user convenience. Their innovative features, from dual cooling systems to smart organizational elements, make them ideal choices for consumers seeking reliability and performance in their kitchen appliances.
Top Page Image Contents