About the refill indicator | Cleaning |
ꞏꞏ |
ꞏꞏ |
ꞏꞏ |
If the indicator on the auto dispenser section lights up, immediately refill the corresponding compartment. A later refill may cause the input level of the agent to decrease. The input or refill level of the detergent or softener depends on the type or the remaining amount of agents.
Once you refill the auto dispenser, the remaining level of the detergent starts to be sensed upon the press of the Start/
Pause (Hold to Start) button. However, the 
indicator may turn off later, depending on the detergent type.
1. | While holding down the release lever on the inner of |
| the drawer, slide open the drawer. |
2. | Remove both the detergent compartment and the |
| softener compartment as shown. |
To refill the detergent or fabric softener
1.Slide open the detergent drawer.
2. Apply an appropriate amount of detergent to the Auto
Detergent compartment (
).
3. If necessary, apply an appropriate amount of fabric softener
to the Auto Softener compartment ( 
).
4. Slide the detergent drawer inward.
CAUTION
Make sure both the auto and manual dispensers are empty before moving the washing machine.
NOTE
ꞏꞏ If the refill indicator continues to turn on after refilling the detergent/softener, press Start/Pause (Hold to Start). The indicator turns off about 10 seconds later.
ꞏꞏ The Refill indicator turns on because it is designed to remind you of the necessity for replenishment of detergent. This is not a system failure.
Troubleshooting
Symptom | Action |
The auto dispenser | ꞏꞏ Check if the detergent drawer is closed properly. |
indicators blink. | −− Open the detergent drawer and close it again. Make sure it’s closed |
(applicable models only) | properly. |
| ꞏꞏ This may happen if liquid detergent has hardened inside the detergent |
| compartment. |
| −− Clean and unclog the detergent compartment. |
|
|
3. | Open the lids of both compartments, and then put |
| water in them and shake. |
4. | Clean the cap valves of both compartments with a soft |
| brush. |
5. | Clean the drawer components in flowing water using a |
| soft brush. |
6. | Clean the drawer recess using a soft brush. Make sure |
| to clean the cap valves to prevent clogging. |
7. | Assemble the compartment cover firmly with the |
| detergent drawer. |
8. | Slide the drawer inward to close it. |
※For details, refer to the user manual.