Screen Display.
The screen shows strange colors or just black and white.
The screen suddenly has become unbalanced.
The screen is out of focus or OSD cannot be adjusted.
Display (OSD) Menu to prevent |
| MENU button for at least 5 seconds. |
changes? |
|
|
|
|
|
Is the screen displaying only one |
| Check the signal cable connection. |
color as if looking at the screen |
|
|
through a cellophane paper? |
| Make sure the video card is fully |
|
| inserted in it's slot. |
|
|
|
Have the screen colors become |
| Reboot the computer. |
strange after running a program |
|
|
or due to a crash between |
|
|
applications? |
|
|
|
|
|
Has the video card been set |
| Set the video card by referring to the |
properly? |
| video card manual. |
|
|
|
Have you changed the video card |
| Adjust screen image position and size |
or the driver? |
| using the OSD. |
|
|
|
Have you adjusted the resolution |
| Adjust the resolution and frequency at |
or frequency to the monitor? |
| the video card. |
|
| (Refer to the Preset Display Modes). |
The screen can be unbalanced due to the cycle of the video card signals. Readjust Position by referring to the OSD.
Have you adjusted the resolution |
| Adjust the resolution and frequency of |
or frequency on the monitor? |
| the video card. |
|
| (Refer to the Preset Display Modes). |
LED is blinking but no images on the screen.
There are only 16 colors shown on the screen. The screen colors have changed
Is the frequency properly adjusted when checking the Display Timing on the menu?
Have the Windows colors been set properly?
Adjust the frequency properly by referring to the video card manual and the Preset Display Modes.
(The maximum frequency per resolution may differ from product to product.)
For Windows ME/2000/XP:
Set the colors properly at the Control Panel, Display, Settings.
after changing the video card.
There is a message that reads "Unrecognized monitor, Plug & Play (VESA DDC) monitor found".
Has the video card been set properly?
Have you installed the monitor driver?
See the video card manual to see if the Plug & Play (VESA DDC) function can be supported.
Set the video card by referring to the video card manual.
Install the monitor driver according to the Driver Installation Instructions.
Install the monitor driver according to the Driver Installation Instructions.
For Multimedia model
Symptom |
| Solutions |
|
|
|
There is no sound.Connect the stereo input jack of the monitor to the stereo output jack of the computer thoroughly by using the voice cable or adjust the volume.
The sound is too weak.
Turn the volume up to MAX.
If the sound is still too weak even after setting the volume on MAX, adjust the volume of the sound card or software program in your computer.
The sound is too sharp.
The sound is too thick.
Turn the volume slightly down.
If using an extensive microphone, adjust the volume while keeping a certain distance from the speaker.