Check List
Before calling for service, check the information in this section to see if you can remedy any problems yourself. If you do need assistance, please call the phone number on the Information section or contact your dealer.
Symptom
No images on the screen. I cannot turn on the monitor.
Check List
Is the power cord connected properly?
Can you see "No
Connection Check Signal Cable" on the screen?
If the power is on, reboot the computer to see the initial screen (the login screen), which can be seen.
Can you see "Not
Optimum Mode", "Recommended Mode 1280 x 1024 60 Hz" on the screen?
There is no image on the screen.
Solutions
Check the power cord connection and supply.
(When connecting 'DVI-A to D-SUB' Cable)
Check the signal cable connection.
(When connecting DVI cable)
If you still see an error message on the screen when the monitor is connected properly, check to see if the monitor status is set to analog.
Make sure that your monitor checks the input signals again by using the input source functionalities provided on the right and left.
If the initial screen (the login screen) appears, boot the computer in the applicable mode (the safe mode for Windows ME/XP/2000) and then change the frequency of the video card.
(Refer to the Preset Timing Modes)
Note: If the initial screen (the login screen) does not appear, contact the Service Center or your dealer.
You can see this message when the signal from the video card exceeds the maximum resolution and frequency that the monitor can properly handle.
Adjust the maximum resolution and frequency that the monitor can properly handle.
The monitor is in PowerSaver mode.
Press any key on the keyboard to activate the monitor and restore the image on the screen.
If this still does not work, start the input source functionalities provided on the right and left of your monitor, or try to move the mouse or press