Connecting to a Power Source
CAUTION
Before inserting any cables or AC adapter, check the directions and do not insert by force. It may cause breakage of cable or camera.
If the charging LED of the AC Charger does not turn on or blink after inserting the rechargeable battery, please check whether the battery is inserted correctly.
If you charge the battery with the camera power on, the battery can't charge fully. Turn the camera off while charging the battery.
Charging LED of the AC Adapter
| Charging LED |
|
|
Being Charged | Red LED is on |
|
|
Charging is complete | Green LED is on |
|
|
Charging error | Red LED is off or blinking |
|
|
A USB cable for transmitting data can’t be used for charging the rechargeable battery.
A USB cable for recharging the battery is optional.
-When the USB cable for recharging the battery is inserted into the connection terminal of the camera, you can charge the battery and transmit data at the same time.
Charging time (When the camera is turned off) - Using the AC Charger : About 150MIN
INFORMATION
If you insert the fully discharged battery to charge it, do not turn on the camera at the same time. The camera may not be turned on because of the low battery capacity. Charge the battery for more than 10 minutes before using the camera.
Do not attempt to use the flash frequently or take a movie clip when a fully discharged battery has only been
Inserting the memory card
Insert the memory card as shown.
- Turn off the camera’s power before inserting the memory card.
- Have the front of the memory card facing toward the back of the camera (LCD monitor) and the card pins toward the front of the camera (lens), and then push the memory card into the card slot until you hear a click.
-Do not insert the memory card the wrong way round. Doing so may damage the memory card slot.
10