Setting the Recorded Pixels and Quality Level
4. Use the | (Manual). |
5. Press the
White Balance
Manual
Adjust 
OK
Manual
White Balance
Point camera at subject
Press the shutter
release button
6.Fully display a white or gray sheet of paper in the viewfinder under the light to adjust white balance.
7.Press the shutter release button fully.
-Slide the focus mode lever to 
when the shutter cannot be released. [OK] appears on the LCD monitor when setting is completed.
[NG] appears when setting is not completed successfully.
8.Press the 
button.
INFORMATION
No image is recorded when the shutter release button is pressed to adjust the white balance. Press the 
button when adjustment is unsuccessful to set again.
You can use [Man. WB Measurement] in the [ 
Custom Setting] Menu (p.100) to set the area to measure for white balance when setting manually. Even if [Entire screen] is selected, white balance of the entire screen is measured normally but the exposure metering is measured according to the [AE Metering] setting in the [ 
Rec. Mode] menu. White Balance is only adjusted in the spot metering area if [Spot metering area] is selected.
If picture is extremely overexposed or underexposed, white balance may not be adjusted. In this case, adjust appropriate exposure and adjust the white balance.