Severe Warning Signs for Installation

Make sure the machine is grounded to prevent electric shock.

Call the contact center for help.

Note.

These warning signs are here to prevent injury to you and others.

Please follow them carefully.

After reading this section, keep it in a safe place for future reference.

SEVERE WARNING SIGNS FOR TRANSPORTATION AND SITE

•When transporting and installing the appliance,care should be taken to ensure that no parts of the refrigerating circuit are damaged.

-Refrigerant leaking from the pipe work could ignite or cause an eye injury. If a leak is detected, avoid any naked ﬂ ames or potential sources of ignition and air the room in which the appliance is standing for several minutes.

-This appliance contains a small amount of isobutane refrigerant(R-600a), a natural gas with high environmental compatibility that is, however, also combustible.

When transporting and installing the appliance, care should be taken to ensure that no parts of the refrigerating circuit are damaged.

• Deteriorated insulation of electrical parts may cause an electric shock or ﬁ re.

•Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room heaters or other appliance.

•Do not plug several appliances into the same multiple power board.

The refrigerator should always be plugged into its own individual electrical outlet which has a voltage rating that matched the rating plate.

-This provides the best performance and also prevents overloading house wiring circuits, which could cause a ﬁ re hazard from overheated wires.

•If the wall socket is loose, do not insert the power plug. - There is a risk of electric shock or ﬁ re.

•Do not use a cord that shows cracks or abrasion damage along its length or at either end.

•Do not pull or excessively bend the power cord.

•Do not twist or tie the power cord.

•Do not hook the power cord over a metal object, place a heavy object on the power cord, insert the power cord between objects, or push the power cord into the space behind the appliance.

-When moving the refrigerator, be careful not to roll over or damage the power cord.

-This may result in an electric shock or ﬁ re.

• Do not use aerosols near the refrigerator.

-Aerosols used near the refrigerator may cause an explosion or ﬁ re.

-Do not bend the power cord excessively or place heavy articles on it.

• This refrigerator must be properly installed and located in accordance with the manual before it is used.

•Do not install the refrigerator in a damp place or place where it may come in contact with water. - Deteriorated insulation of electrical parts may cause an electric shock or ﬁ re.

•Connect the power plug in proper position with the cord hanging down.

-If you connect the power plug upside down, wire can get cut off and a cause ﬁ re or an electric shock.

• Make sure that the power plug is not squashed or damaged by the back of the refrigerator.

• When moving the refrigerator, be careful not to roll over or damage the power cord.

-This constitutes a ﬁ re hazard.