Samsung HT-XA100T/MEA manual Setting the DRC Dynamic Range Compression, Setting the AV Sync

system setup

Manually Adjusting the Speaker Volume and Balance with the SOUND EDIT Button.

Press the SOUND EDIT button and then press the Cursor ◄, ► button.

• Each time you press the SOUND EDIT button, you can see the balance and level for each speaker.

Adjusting Front/Rear Speaker Balance

You can select between 0 dB, -6 dB, and OFF.

The volume decreases as you move closer to – 6 dB.

Adjusting Center/Rear/Subwoofer Speaker Level

The volume level can be adjusted in steps from +6dB to –6dB.

The sound gets louder as you move closer to +6dB and quieter as you get closer to -6dB.

SETTING THE DRC (DYNAMIC RANGE COMPRESSION)

This feature balances the range between the loudest and quietest sounds. You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.

1.In Stop mode, press the MENU button.

2.Press the Cursor ▼ button to move to Audio and then press the ENTER or ► button.

3.Press the Cursor ▼ button to move to DRC and then press the

ENTER or ► button.
4. Press the Cursor ▲, ▼ to adjust the DRC.	MOVE ENTER RETURN EXIT

•When the Cursor ▲ button is pressed, the effect is greater, and when the Cursor ▼ button is pressed, the effect is smaller.

d Press the RETURN button to return to the previous level.

dPress the EXIT button to exit the setup screen.

CHANGE RETURN EXIT

SETTING THE AV SYNC

Video may look slower than the audio if it is connected to a digital TV. If this occurs, adjust the audio delay time to to match the video.

1.In Stop mode, press the MENU button.

2. Press the Cursor ▼ button to move to Audio and then press the ENTER or ► button.

3.Press the Cursor ▼ button to move to AV-SYNC and then press the ENTER or ► button.

4. Press the Cursor ▲, ▼ button to select the AV-SYNC Delay Time	MOVE ENTER RETURN EXIT
and then press the ENTER button.

•You can set the audio delay time between 0 ms and 300 ms. Set it to the optimal status.

dPress the RETURN button to return to the previous level.

dPress the EXIT button to exit the setup screen.

MOVE SELECT RETURN EXIT

SETTING THE HDMI AUDIO

The audio signals transmitted over the HDMI Cable can be toggled ON/OFF.

1.In Stop mode, press the MENU button.

2. Press the Cursor ▼ button to move to Audio and then press the ENTER or ► button.

3.Press the Cursor ▼ button to move to HDMI AUDIO and then press the ENTER or ► button.

4. Press the Cursor ▲, ▼ button to select ON or OFF and then press

the ENTER button. MOVE ENTER RETURN EXIT

•ON : Both video and audio signals are transmitted over the HDMI connection cable, and audio is output through your TV

speakers only.

•OFF : Video is transmitted over the HDMI connection cable only, and

audio is output through the home theater speakers only.

dPress the RETURN button to return to the previous level.

MOVE SELECT RETURN EXIT

dPress the EXIT button to exit the setup screen.

M The default setting of this function is HDMI AUDIO OFF.

 HDMI AUDIO is automatically down-mixed to 2ch for TV speakers.

GB

● SYSTEM SETUP

50 51